Explore our large selection of top rated products at cheap prices from. Every Dream Maker Spa Part you could possibly need to get your hot tub running again. Read honest and unbiased product reviews from our users. Find helpful customer reviews and review ratings for 4 Person DreamMaker Spa X-400 Portable Hot Tub 11 Jets - 1.5 HP - 110v 15 amp - 200 Gal. Leak, discharge line from pump had obviously broken at some point, probably.

The pump runs until it reaches temperature setting (they obviously didn't know, no manual). It is a 2006 Dream Maker Spa, x400.120 volt. Up or down via buttons, it would flash '56' then go back to allowing me to attempt to change temperature. Also the display would go back to its default 100 degree setting (the default temp after plugging it in) and when you try to push the temp.

The light would be on it's fade program, but flashing intermittently with the speed of the clicking. A small clicking noise started to come from the engine area. Starting last night, after my wife pressed the light button once or twice, (could have just been a coincidence timing wise) the spa started acting weirdly. So, we hooked it up last saturday, and everything is going very well.

Once you finished push any button and reset your temperature.So I finally bought my first spa. To put the hot tub in (Sy) mode simply lower the temperature using the down temperature button to its lowest setting 20☌ or 70☏ and once there within two seconds click the lower temperature button one more time. There is also the standby mode (Sy) which allows you to change or clean your filters without disrupting your previous settings. To change between each filter mode on a Dream maker Spa first push either the decrease or increase temperature button followed by the light button which will put you into the mode selection, then with the temperature buttons you can toggle between the 3 modes to chose your desired filtration and heating mode. This is a great mode to leave your hot tub on when you are away.

The Sleep Mode (SL) works in the same way that the (EC) mode works but automatically sets the temperature to 20 degrees less. This mode will help you save money on your electrical costs. The Economy Mode (EC) which has the heater come on during scheduled filtration cycles that you can set to off peak electrical hours. The Dream Maker spa gives you many options as far as filtration and heating to chose from there is the factory set Standard mode (ST) and the most used setting which has the heater come on as needed to keep your desired temperature. The Dream Maker spas use a Balboa topside control. How to change the pump and filter mode setting on a Dream Maker spa or hot tub has come up a few times with our customers so we thought we would offer this post to guide you through the process.

Dream maker x400 manual